Clean, chemical-free foam removal for lofts, roofs and rafters

Dry ice blasting spray foam removal in Harrogate

Our dry ice blasting spray foam removal in Harrogate lifts open cell and closed cell spray foam off rafters, tiles and timbers without water, solvents or grit. We work across North Yorkshire on lofts, attics and roof voids where foam has trapped damp, blocked a survey or stalled a mortgage. Most jobs are cleared in a day, with the timber left dry, intact and ready for your lender's inspection.

↗
Fast online booking

Request service today

Tell us what is happening. Our local team will confirm your visit shortly.

No spam. No obligation. Just practical help.
Thanks — we'll call shortly to confirm your visit.
dry ice blasting spray foam removal by Spray Foam Removal Harrogate
Careful work. Honest options.
About this service

dry ice blasting spray foam removal in Harrogate explained

Dry ice blasting spray foam removal in Harrogate uses compressed air to fire soft dry ice pellets at the foam. The pellets hit at around -78C, freeze the polyurethane foam until it turns brittle, and the impact lifts it clean off the substrate. There is no water, no sand blasting media and no chemical stripper, so the timber stays dry and the loft does not need days to dry out. We then collect the debris with an industrial vacuum and a dust extraction unit.

Harrogate has a lot of older stone and brick homes with slate or tile roofs, and foam sprayed into those roof voids in the 1990s and 2000s is now causing problems. Trapped condensation rots rafters, hides leaks and blocks ventilation, and surveyors flag it in almost every report. If you have been searching for dry ice blasting spray foam removal in Harrogate near me, we cover every postcode in the town and the surrounding villages.

  • ✓ No water, no drying time
  • ✓ Timber stays intact
  • ✓ Mortgage and survey friendly
  • ✓ Chemical-free and low dust
What's included

What our dry ice blasting service includes

Every job includes the survey, the blasting, the clean-down and the paperwork. We tell you upfront if anything extra is needed, such as roof repairs or timber treatment, so there are no surprises on the day.

✓

Free loft survey and quote

We inspect the foam type, thickness and coverage, check for damp and rot with a moisture meter and boroscope, and give you a fixed price the same day. The survey and quote cost nothing.

✓

Full containment and protection

Protective sheeting over floors and stored items, sealed loft hatch, air scrubber and dust extraction unit running throughout. Dust and debris stay in the loft, not in your living space.

✓

Dry ice blasting and vacuuming

We blast the foam off rafters, tiles and purlins with the dry ice blasting machine, then vacuum up all loose foam, dust and pellets with an industrial vacuum. The loft is left clean and dry.

✓

Timber and ventilation check

After blasting we check the timbers with a moisture meter and thermal imaging camera, confirm ventilation is open, and flag any rot, leaks or structural damage we find before we leave.

✓

Photo record and handover

We photograph the cleared loft and log moisture readings, then walk you through what we found. The photos and readings are yours to pass to your lender, surveyor or building control officer.

How it works

How our dry ice blasting process works

01

Free loft survey

We inspect the loft, check the foam type and thickness, and look for roof rot, damp or hidden leaks with a boroscope and moisture meter. You get a fixed price the same day, usually within an hour of us arriving.

02

Protect and seal

We lay protective sheeting over floors, joists and any stored items, then seal the loft hatch and any gaps with dust barriers. An air scrubber and dust extraction unit run throughout so dust and debris stay in the loft, not in your hallway.

03

Dry ice blasting

Our technician works across the rafters, tiles and purlins with the dry ice blasting machine, adjusting pressure for open cell or closed cell spray foam. A typical three-bedroom semi takes four to six hours of blasting.

04

Debris removal

Loose foam, dust and pellets are vacuumed up and bagged. We check the timbers again with a moisture meter, and if we find rot or a leak we tell you before we leave rather than after.

05

Final check and handover

We photograph the cleared loft, confirm ventilation is open and walk you through what we found. If your lender or surveyor needs evidence, the photos and moisture readings are yours to pass on.

Tools & methods

Tools and methods we use

Purpose-built equipment, used by trained technicians — so the job is done accurately the first time.

Dry ice blasting machine

Fires food-grade dry ice pellets at around -78C to freeze and lift foam off rafters and tiles without water or grit.

Industrial vacuum and dust extraction unit

Captures loose foam, dust and spent pellets during and after blasting, keeping the loft and the rest of the house clean.

Air scrubber

Filters airborne particles in the loft while we work, which matters in occupied homes and where asthma or allergies are a concern.

Moisture meter and thermal imaging camera

Checks timber moisture content and finds hidden damp or leaks behind rafters before and after foam removal.

Boroscope

Lets us inspect inside roof voids, eaves and wall cavities where we cannot see directly, so nothing is missed.

Spray foam removal saw and oscillating multi-tool

Used for cutting back thick closed cell foam in tight corners where blasting alone is not practical.

Real results

Before and after.

Stalled mortgage in Harrogate Town Centre

Before

A Victorian terrace loft was full of open cell foam sprayed between rafters. The buyer's surveyor flagged it, the lender withheld funds and the sale was on hold. Condensation had darkened the rafters and the loft smelled musty.

After

We removed the foam in a single day, vacuumed the loft and logged moisture readings across every rafter. The timbers were dry within 48 hours, the lender released the mortgage and the sale completed two weeks later.

Damp rental roof void in Starbeck

Before

Closed cell foam in a rental semi had trapped moisture against the rafters, and condensation was dripping onto the ceiling below. The landlord had already replaced a stained ceiling panel once and did not want to do it again.

After

We blasted the closed cell foam off in six hours, found a cracked tile the foam had been hiding, and restored ventilation. The ceiling has stayed dry through two winters and the tenant has reported no damp.

Foam over-spray in a Pannal Ash semi

Before

Foam over-spray had blocked the eaves vents in a 1930s semi, so the roof void could not breathe. The owner noticed a musty smell in the back bedroom and dark patches on the rafters near the eaves.

After

We cleared the over-spray and foam in five hours, opened the ventilation path and treated early timber decay. Moisture readings dropped from 24 percent to 14 percent within a week and the musty smell cleared.

Problems we solve

Problems dry ice blasting spray foam removal solves

Foam that was sold as insulation often does the opposite. These are the problems we see most often in Harrogate lofts, and what happens if they are left alone.

Ask a pro →
01

Mortgage refused because of spray foam in the loft

We remove the foam, check the timbers and provide photos and moisture readings your lender needs. Most Harrogate clients get their mortgage offer released within two to three weeks of the foam coming out.

↗
02

Condensation and damp trapped against roof timbers

Dry ice blasting clears the foam without adding water, and we restore ventilation so the roof void can dry. We check moisture levels with a meter and treat any early timber decay before it spreads.

↗
03

Hidden leaks and cracked tiles under the foam

Once the foam is off, we inspect the roof covering and use a boroscope and thermal imaging camera to find leaks and damp patches. You get a clear picture of what needs repairing before it becomes a bigger job.

↗
04

Insulation over-spray blocking eaves ventilation

We clear over-spray from the eaves and rafters, confirm the ventilation path is open, and advise on breathable insulation that will not block airflow. The loft ends up drier and easier to inspect.

↗
Proof you can check

Accredited, insured and accountable

✓
CHAS AccreditationCHAS
✓
SafeContractor ApprovalSafeContractor
✓
Constructionline RegistrationConstructionline
✓
PASMA TrainingPrefabricated Access Suppliers' and Manufacturers' Association
✓
CSCS CertificationConstruction Skills Certification Scheme
Good questions

Frequently Asked Questions

03335672543 →

Most lofts in Harrogate run between 900 and 2,400 pounds in 2026, depending on foam type, thickness and access. A standard three-bedroom semi with open cell foam usually sits near the lower end, while large detached homes with closed cell foam and difficult roof voids sit higher. The survey and quote are free.

Yes. Lenders and surveyors routinely refuse mortgages where spray foam is present because it hides rot and blocks ventilation. Once the foam is removed and the timbers are checked, we provide photos and moisture readings that show the roof void is clear, dry and ventilated, which is what lenders need to release funds.

A typical three-bedroom semi takes one day, with four to six hours of blasting plus clean-down. Larger detached homes, warehouses or heavy closed cell foam can take two to three days. We give you a realistic timeframe at the survey, not a best-case guess.

If foam is trapping damp, you can see condensation on the rafters, the roof void smells musty, or a surveyor has flagged it, you need it removed. Foam that is dry, well ventilated and not causing rot may be left alone. We will tell you honestly at the survey which category your loft falls into.

Ready when you are

Book dry ice blasting spray foam removal in Harrogate

Call 03335672543 for a free loft survey and a fixed price the same day. We are CHAS and SafeContractor accredited, we work to BPCA containment standards, and we leave your loft dry, clear and ready for your surveyor.

Get a free quote 03335672543 →
Request an appointment

Contact our Harrogate team

Call us on 0333 567 2543 or email info@sprayfoamremovalharrogate.com and we will get back to you the same working day. Our phone line stays open 24/7 for emergency foam removal, and we can usually survey your roof within 48 hours of your first call.

Request received — our team will be in touch shortly.
Tap to call03335672543